When repairing or servicing a car, from time to time it is necessary to unscrew the bolts or nuts that are in hard-to-reach places. And to unscrew the bolt, you have to be very sophisticated.
Therefore, for the convenience of unscrewing them, the master proposes to make an extension handle, which is suitable for both open-end and ring spanners. With such a simple device, you can reach anywhere under the hood.
To make this home-made fixture, you will need a piece of steel pipe and two small pieces of metal corner. These "accessories" can be found in any garage without any problems.
The process of making a homemade extension handle
The first step is to cut a piece of tube that is suitable for the length. The diameter must be chosen so that the extension handle comfortably rests in the hand. Then two sections of the corner are welded to the bottom of the pipe.
After welding, the welds will need to be cleaned with a grinder with a flap wheel or on a belt grinding machine (grinder).
Actually, the device itself is ready - it remains only to paint it, and install a wrench between the corners. As you can see, this homemade product will not take much time, and the materials are quite affordable.
For a detailed process of making a homemade extension handle for an open-end wrench, see the video on our website. Write in the comments below the video, did you like this homemade product or not?
