Share
Pin
Tweet
Send
Share
Send
I need this table to show my homemade products.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol.jpg)
And to make it very simple.
For the construction we need:
- - motor from the microwave;
- - switch;
- - network wire;
- - chipboard or plywood;
- - self-tapping screws;
- - corner.
To begin with, we cut a cutout under the motor at the base. I decided to leave the native connector and sawed out a little more.
Base dimensions 250 * 100 mm. Plywood 18 mm thick.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-2.jpg)
Pancake table with a diameter of 230 mm.
In the center we drill a hole for the motor, so that the axis fits tightly into the pancake table.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-3.jpg)
I have plywood frayed, since boo. At first I thought of walking it with sandpaper, which I did, but then I decided to paint it black. When everything was dry, I drilled a hole for the wires.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-4.jpg)
Further.
Mark the place under the motor. We drill a hole half thinner than the self-tapping screws so that the plywood does not crack. We fasten the motor.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-5.jpg)
Now we are going to install the switch.
In the role of the latter, I have a toggle switch TP 1-2. What was then applicable. Installed it on an aluminum corner. There was already a hole in the corner, but I finished it with a file.
Run the wires into the pre-made hole and connect to the toggle switch.
We fasten the corner to the screws. We can use any corner for your switch.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-6.jpg)
By motor. I have it at 220 volts If the microwave ovens in which the motors are installed at 21 volts (I came across such). In this case, you need a transformer or can be powered by a microwave board. In the latter case, the design becomes large.
Although the motor speed is only about 3 revolutions per minute, I decided to screw the legs.
To surely exclude the crawling of the table on the surface.
In the role of legs, rubber stoppers for drugs.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol-7.jpg)
The finished design will look decent. There was an idea to paint the pancake white, but the paint was only water-based and not suitable for the purpose.
![](http://img.uaft2404.org/img/sdela-2019/povorotnij-stol.jpg)
ATTENTION! The device is powered by a household network. Take measures to insulate the wires at the point of connection to the switch.
Thanks for your attention!
Watch the video:
The design was developed by Mastyrkin.
Share
Pin
Tweet
Send
Share
Send