Barrette

Pin
Send
Share
Send

In order to make such a hairpin, you will need:
• Three satin ribbons 5 cm wide.
• A piece of organza 25? 5 cm.
• Cardboard.
• Scissors.
• Ruler.
• Candle or lighter.
• Moment glue or glue gun.
• Rhinestones, beads.
• Elastic band for hair (bezel, automatic hair clip).

To begin with, you will have to cut squares (5? 5 cm.) From ribbons. For convenience, measure the tape with a ruler and mark with a pencil, and only then cut it off. Such squares must be cut into seven pieces of each color.

Singe the edges of the ribbons so that they do not bloom, and it is more convenient for you to work with the fabric.

You can start folding the kanzashi petal. Connect the two opposite corners of the square to make a triangle.

Fold the blank in half as shown in the photo.

Then fold it in half again to make such a sharp petal.

So that it does not fall apart, it is necessary to scorch the edge and press it still hot.

Trim the excess and also process the ribbon with fire.

The classic petal for the first row of the flower is ready. Make six more of these petals.

Next, from the tape of a different color, fold the same petals. In total, they will need seven.

For the second row of petals we use a ribbon of contrasting color, in the photo it is a silver ribbon.

Fold the petal in the same way as the previous time, only after the last fire treatment, press with your fingers the place where the ribbon melted. And then twist the workpiece. You should get such a petal.

Complete six more such blanks.

All the petals are ready. Heat the glue gun and glue the two petals as shown in the photo below. You can use the Moment glue, but then you have to wait a little longer until the glue hardens.

For the base, take a piece of cardboard and cut a circle from it, with a diameter of 3-4 cm. On both sides, attach ribbons.

We form the first row of the flower. To do this, glue seven petals in a circle, leaving a little space in the middle.

In the second row also glue seven petals. This time it’s a little closer to the middle.

Now cut 5-5 cm squares from the organza and make the same petals as for the second row. There should be only five of them. Then stick them in the middle.

To make the flower even more elegant, make six more petals as for the second row and stick them as shown in the photo.

From thin ribbons, as in the first embodiment, or from beads as in the second, make stamens. Glue the jewelry onto a hair elastic, hairpin or bezel.

Stick rhinestones or one large bead in the middle of the flower. The kanzashi hairpin is ready!

Pin
Send
Share
Send

Watch the video: How to Wear Trendy Hair Clips - KayleyMelissa (November 2024).